Select a band to view its sweep. Connect your VNA Air bridge before starting a measurement.
SWR colors: <2 green · 2–<3 yellow · 3–4 orange · >4 red. Quick overview is coarse and may miss narrow minima; verify promising bands with a full 101-point sweep.
Lowest SWR--
Resonance
-- MHz
Under 2:1
--
Run a band sweep to see the response
US band edgesCW / data-restricted segmentsOperating guidance is voluntary; local band plans vary.
-- MHz · SWR --
NanoVNA screen
Capture the NanoVNA's own screen to compare it with the plot above.
Multi-band antennas
Resonance spectrum
Sweeps a wide range continuously and marks every SWR dip, so you can see whether tuning one band moves the others. Set a baseline before you adjust.
Start a scan to find resonances
Not scanning
No resonances measured yet.
Bridge configuration
Setup
Connect to a VNA Air bridge and check its USB link to the NanoVNA.
⌁
Bridge statedisconnectedConnect to a VNA Air bridge
NanoVNA USB
OFFLINE
Protocol
--
Uptime
--:--
NanoVNA model
--
NanoVNA firmware
--
No telemetry
More points take longer. Calibration stays at 101 points, so sweeps above that use interpolated calibration.
Calibration
– Not connected
Known range
—
Calibration flags
—
Connect to a VNA Air bridge to read the analyzer's calibration state.
The NanoVNA cannot report its calibrated range. The range is shown as “set by VnaAir” for a calibration the bridge ran itself, and as “read after loading slot N” after Load saved calibration: the bridge then reads back the sweep range stored in the slot, which is the calibrated range for any slot saved by VnaAir. A range changed on the touchscreen, or a slot recalled there that leaves the same flags, cannot be detected. A USB re-plug or a bridge restart clears it.
Diagnostics
Combines the bridge log (kept across bridge resets, cleared on power loss) with this app's event log.
About this app
Web app build
--
Checking…
Simulated calibration
Each tap moves the simulated NanoVNA to the next calibration state.